The relevant information relating to each product appears on the Certificate of Analysis (CoA) that is shipped with the product. Please read this information carefully to obtain instructions for reconstitution and storage. If, after reading the CoA, you need additional information, please review the following set of questions and answers, or call our Quality Assurance Department at [email protected] or 800-436-9910 prompt number 4.
1. What should I know about the stability of your protein products?
Unless otherwise mentioned on the product information sheet, all of our products are formulated in such a manner that the lyophilized proteins are very stable at room temperature. However, we recommend storing lyophilized products at -20°C to -80°C.
For reconstituted solutions of most products, we recommend short-term storage at 4°C. For extended storage, the protein solution should be stored with a carrier protein (e.g. 0.1% BSA) in working aliquots and stored at -20°C to -80°C. Aliquots should be prepared to a concentration no lower than 1μg/ml, and contain at least 10μl, independent of concentration.
Please keep in mind that every freeze/thaw cycle may cause some denaturation of the protein; therefore, we do not recommend subjecting aliquots to more than a single freeze/thaw cycle.
2. What endotoxin level should be expected when purchasing PeproTech proteins?
For PeproTech’s Animal-Free proteins, the endotoxin level is guaranteed to be less than 0.01 ng/μg of protein, or 0.1 EU/μg. For most of PeproTech’s non-Animal-Free proteins the endotoxin level is guaranteed to be less than 0.1 ng/μg of protein, or 1 EU/μg. However, for many proteins, the actual measured endotoxin values are consistently below these stated endotoxin levels. Please contact our Quality Assurance Department ([email protected]) for more information.
3. Why can’t I see the protein pellet in the vial?
Unlike many protein products available on the market, PeproTech products are not formulated with carrier proteins or other additives (e.g., BSA, HSA, sucrose, etc.). As a result, the small amounts of protein can be deposited on the vial during lyophilization as a thin, and sometimes invisible, film. Before opening, we recommend centrifuging each vial in a microcentrifuge for 20-30 seconds to drive any protein that may be lodged in the cap or on the side to the bottom of the vial. Our quality control procedures assure that each vial contains the correct amount of product.
4. Which cytokines show cross-species activity?
With a few exceptions, most human cytokines are active on mouse cells. Many mouse cytokines are active on human cells, but may show lower specific activity than the corresponding human cytokine. The interferons, GM-CSF, IL-3, and IL-4 are known to be species-specific with very little, if any, activity on non-homologous cells. In contrast, the FGFs and neurotrophins are very highly conserved and show excellent activity on cells of other animal species.
5. What is the relationship between the specific activity expressed as an ED50 and as units/mg?
While ED50 is defined as the cytokine concentration at which activity is 50% of the maximum response, specific activity is defined as a measurement of reaction rate (i.e. activity) in relation to the amount or mass of a substance. Specific Activity Units should only be used as a method of expressing potency and should only be calculated for sigmoidal dose-dependent curves. The formula for converting activity expressed as an ED50 in ng/ml to specific activity in units/mg is: